Address:   V Zavetri 6/1478
170 00 Prague 7
Czech Republic
Phone:   +420 212 248 670
+420 736 535 095
Česky English 
 

CpuArm01 – Processor board with ARM9 180 MHz

CpuArm01 – Processor board with ARM9 180MHz
  • CPU ATMEL ARM9 – 180MHz
  • 126 MIPS Dhrystone 2.1
  • SDRAM 32 MB
  • FLASH 2 MB
  • 4× RS232
  • CAN 1 Mbit, electrically isolated
  • LAN 10/100BASE–T
  • USB 2.0 Device
  • XBus interface for connecting extension boards
  • SD/MMC slot
  • Watchdog
  • battery-backed realtime clock
  • batery-backed SRAM 512 kB
  • bootloader for software uploading through RS232 interface
  • power supply voltage 7–27 VDC

Description

CpuArm01 is processor board of control system equipped with processor Atmel ARM9 working at 180 MHz and SDRAM 32 MB memory. Software equipment can be installed on embedded FLASH memory or removable SD/MMC card.

Processor board is also equipped with battery-backed SRAM 512 kB, Watchdog, electrically isolated CAN bus, four RS232 interfaces and XBus interface for connecting extension boards.

Embedded bootloader allows uploading software equipment directly through RS232 interface.

Technical parameters

  • Power supply voltage: 7–27 VDC
  • Power consumption: 120 mA @ 24 V, 200 mA @ 12 V (without extension boards)
  • Operating temperature: 0-70°C
  • Procesor
    • Type: ATMEL ARM9 180 MHz
    • RAM: 16 kB
    • Cache: 16 kB data, 16kB instruction, Write Buffer
  • DRAM
    • Type: SDRAM 2×16bit
    • Capacity: 32 MB
  • FLASH
    • Capacity: 2 MB
  • SD/MMC slot
    • Typ: Push/Push
    • Supported cards: SD, SDHC, MMC
  • USB
    • Typ: USB2.0 Device
    • Speed: full speed, 12 Mb/sec
  • Ethernet
    • Type: 10/100BASE-T
    • Speed: 10/100 Mbit
    • Duplex: half/full
    • Indication: receive/transmit, 10/100 Mbit
  • XBus
    • Data: 8 bit
    • Adress: 8 bit
    • Interrupts: 2
    • Power supply for extension boards: 5 VDC, max. 4 A
  • RTC
    • Date: year, month, day, day of week
    • Time: hours, minutes, seconds, tenths and hundredths
    • leap years to y.2100
    • automatic storage of turn-off time
    • SW calibration
  • RS232 interface
    • Number of independent interfaces: 4
    • Connector: 3 pins
    • Signals: TxD, RxD, GND
    • Baudrate: programmable up to 230400 bps
  • CAN interface
    • Connector: 3 pins
    • Signals: CANH, CANL, GND
    • Bitrate: programmable up to 1Mbit
    • Electrically isolated: yes
    • Indication: receive/transmit

Software equipment

User application written C or C++ can be uploaded through JTAG or RS232 interface. For software development common development tools (GCC, IAR) can be used. C libraries with routines for peripheral are available.

Documentation

User manual User manualproduct version 1revision 1128.4 KiBCzech

Updated:
5/4/2016